User's Manual

3K\VLFDO&RQQHFWLRQV
 6DYL5)5HOD\5)5DQG5)5,QVWDOODWLRQ*XLGH
» To connect the up/down converter to the NEMA enclosure:
1. Using the 153 dm (50 ft.) cable, which has a male connector
at each end, attach the smaller of the connectors to the
antenna-cable port on the RF Relay.
The antenna-cable port is the farthest to the left side on the
bottom of the relay NEMA enclosure, as shown in Figure 2-5.
)LJXUH 5)5HOD\%RWWRP9LHZ
2. Turn the connector clockwise until it is firmly attached to
the antenna-cable port.
3. For the Model UDC2.4B-0C converter: Attach the other
connector to the female port on the side of the up/down
converter.
4. For the Model UDC2.4C-0C converter: Attach the other
connector to the converter port marked IU (indoor unit).
5. Turn the connector clockwise until it is firmly attached to
the up/down converter.
Antenna
Cable
Network In Network Out AC Fuse
Holder
Power
Cable