User's Manual

6DYL5)5HOD\5)5DQG5)5,QVWDOODWLRQ*XLGH 

,QVWDOODWLRQ 2
Installing the Savi RF Relay requires pre-planning your hardware
needs to match your site and application. Discuss site-specific
issues with your Savi customer service representative. The Savi
System Installation Guide (Savi part number 805-00968-010/
order number JDM-1004) describes the overall process of
planning an RFID network.
This chapter describes the RF Relay installation process.
To comply with FCC Section 1.1307 for RF exposure
requirements, a minimum separation distance of 2m
(79 inches) is required between the antenna and all
persons.
Note: The Savi RF Relay is used in sophisticated wireless data
networks. The RF Relay is not sold to the general public.
Unless installation is performed by knowledgeable
personnel with both software and RF experience, nodes
in the WLAN are likely to be incorrectly configured, with
the result that the entire network is compromised or
rendered inoperable.