User's Manual

Savi Tag ST-696-001 ISO Container Door Tag with GPRS/GPS and Sensors Installation Guide

Charging the Tag Battery

Savi Tag ST-696-001 ISO Container Door Tag is equipped with

non-volatile memory, which means stored data is not lost when the

battery is fully depleted.

1. Using a coin or flat-head screwdriver, turn the charging plug

cover counterclockwise.

When removing the charging plug cover, hold on to it to avoid

dropping it.

2. Plug wall adapter (provided) into the standard AC outlet.

3. Plug the wall adapters’ plug into the power jack on the tag.

Charging of fully depleted battery may take from 10-12 hours. In

order to check whether the battery if fully charged remove that

plug and wait for the tag to complete power up sequence. After

several seconds the Tag will beep with 4 consecutive beeps. The

fourth beep indicates battery charge state. If the fourth beep is

short then the battery is full. If the fourth beep is long than the

battery is low and if it is missing (only 3 beeps heard) the battery

is still not fully charged. If the battery is not fully charged reconnect the wall adapter plug back into the units and

wait until tag reports fully charged battery status.

After completing the battery charging using a coin or screwdriver.

With the coin placed in the power plug cover groove, push the cover in. Turn the plug cover

counterclockwise 1/4 to 1/2 of a turn to properly seat the cover. Turn the battery cover clockwise until it

fits flush with the tag case. Be careful not to overtighten. Make sure the plug cover is completely closed

and that it is not cross-threaded.