User Manual

CHAPTER 2
Savi SensorTag ST-676-I ISO Container Door Tag with Sensors Installation Guide 9
Installing Savi SensorTag
ST-676-I ISO Container
Door Tag with Sensors 2
Required Tools and Materials
Before you begin installation, make sure the following materials are available:
◆ Savi SensorTag ST-676-I ISO Container Door Tag with Sensors
◆ SaviTag Write Cable STA-1030
◆ One 3.6V lithium battery, size A (provided)
◆ A coin or flat-head screwdriver
Commissioning the Tag with SaviTag
Write Cable STA-1030
You can commission Savi SensorTag ST-676-I ISO Container Door Tag
with Sensors using SaviTag Write Cable STA-1030. You can also
commission a tag using Savi software that operates on a mobile device,
such as the Intermec® 741G/A or 751G/A Mobile Computer with an
attached Savi
®
Mobile Reader SMR-650. You can purchase the cable,
software, and mobile device separately.
Note: Savi SensorTag ST-676-I ISO Container Door Tag with Sensors is
shipped from the factory with the battery installed in the reverse direction
to preserve battery life. Before you attempt to commission the tag, make
sure the battery is properly installed. See “Replacing the Battery” on
page 11.