User Manual

CHAPTER 2
Savi ST-656-I ISO Container Door Tag Installation Guide 9
Installing Savi ST-656-I
ISO Container Door Tag 2
Required Tools and Materials
Before you begin installation, make sure the following materials are available:
◆ Savi ST-656-I ISO Container Door Tag
◆ SaviTag Write Cable STA-1030
◆ One 3.6V lithium battery, size A (provided)
◆ A coin or flat-head screwdriver
Commissioning the Tag with SaviTag
Write Cable STA-1030
You can commission Savi ST-656-I ISO Container Door Tag using SaviTag
Write Cable STA-1030. You can also commission a tag using Savi software
that operates on a mobile device, such as the Intermec® 741G/A or 751G/A
Mobile Computer with an attached Savi
®
Mobile Reader SMR-650. You
can purchase the cable, software, and mobile device separately.
Note: Savi ST-656-I ISO Container Door Tag is shipped from the factory
with the battery installed in the reverse direction to preserve battery life.
Before you attempt to commission the tag, make sure the battery is
properly installed. See “Replacing the Battery” on page 11.