User Manual

ST-675-SIAD-001 Tag
Mounting Guidelines
805-00008-901 Rev 01 sheet 11 of 11
MOUNTING GUIDELINES, ST-675-SIAD-001 TAG
3.3 Tag Installation
The Tag should be attached prior to cooling the container. This will allow for the fastest cure
time. To fasten the tag to the container:
1. Remove red liner from 3M VHB tape to back of mounting plate. Make sure tape is
located so it will make good contact with metal surface and NOT any rubber gasket
material.
2. Press Tag half into position.
3.4 Setting Door Alarm Lever
Once the tag is attached into the container the door sensor alarm must be adjusted. Utilizing
the SMM handheld, and the supplied adjustment tool, adjust the extension arm as to set the
door sensor to 75.
3.5 Flex circuit
Ensure that the flex circuit is inserted in the container as the right side door is shut, not
allowing any excess that may exist to extrude to the outside.