User's Manual

Savi ST-674 Sensor Tag Installation Guide
8
Then, if the tag emits a long (1/2 second beep), that means it has an
internal sensor failure.
Then, the tag will emit 2 short beeps to indicate adequate battery
voltage or 3
short beeps if a fresh battery is required.
Whenever a battery is inserted into a t
ag, the tag assumes that it is a
fresh battery. Inserting a used battery into a tag may result in what
appears to be a premature battery failure.
3. Replace the battery cap on the tag. Continue tightening the cap until
it is secure.
Improper
O-ring exposed
Turn cap
until tight
Proper
O-ring hidden
If the O-ring is not properly compressed by the cap, water leakage and
damage may occur.
Note: When the tag is not in use, disable the tag by removing, reversing,
and re-inserting the battery. Store the battery at room temperature
(50-80 °F or 10-27 °C ).