User's Manual Part 2

Mounting Savi SensorTag ST-674
Savi SensorTag ST-674 Installation Guide 17
1. Clean the location on the container where the mounting sleeve is to be
attached.
2. Obtain a mounting sleeve
with PST installed and
carefully remove the red
protective film covering.
Avoid touching the PST
adhesive.
3. Position the sleeve horizontally or vertically, making sure there is at
least 4 inches (10 cm) of clearance at the opening of the sleeve to allow
the
Savi SensorTag ST-674 to be inserted. Be sure that the surface to
which you will apply the tape is flat, and that the sleeve can move
freely to compress the tape in the next step.
4. When the sleeve is level,
press it into place. Apply
pressure to the tape strips
by pushing firmly against
the inside surface of the
sleeve. To assure a good
bond, apply as much finger
pressure as possible and
work fingers on the area
over the tape strips.