User's Manual

Nut Gasket
Mounting the Tag
13
4. Remove the small rubber gasket washer from the mounting bracket.
5. To mount the tag, insert the mounting bracket and tag into the port
opening.
6. Apply pressure to the tape strips by pushing firmly against the tag.
Press as hard as possible on the top of the bracket and tag.
7. On the inside of the container, replace the small rubber gasket washer
and screw the nut onto the hollow screw stem to secure the tag. Close
the jet engine container.
8. If the port opening on the container is too large for the tag to be
mounted securely, insert a metal shoulder washer before replacing the
rubber washer and nut. Ensure that the lip on the metal shoulder
washer is inserted through the orifice and is facing the outside of the
container. The metal shoulder washer must be ordered separately.