User's Manual Part 1

CHAPTER 2 Installing the Tag
10 Savi SensorTag ST-673 Installation Guide
Commissioning a Tag
Savi SensorTag ST-673is shipped from the factory in sleep mode. Before
you attempt to commission a tag, refer to Guide to Savi SmartChain for
Mobile Devices to wake the tag.
Note: You can also remove and re-insert the battery to wake up the tag.
You must wait a few seconds before re-inserting the battery.
You can commission Savi SensorTag ST-673 using Savi Tag Write Cable
STA-1030, Savi Tag Write Cable Adapter STA-1031, or docking station
with a docking station adapter model SDSA-654-01. You can purchase
these units separately. Ensure that the metal mounting sleeve is removed
before you start commissioning a tag. See “Removing the Mounting
Sleeve” on page 9.
2. Remove the front of the
mounting sleeve.
3. Slide the tag from the
mounting sleeve.