User's Manual

&RQQHFWLQJ6\QF&DEOHVWR6DYL6LJQSRVW63;6HULHV
6DYL6LJQSRVW63;6HULHV,QVWDOODWLRQ*XLGH 
 Connect the power cable to the signpost power connector, as shown in
Figure 3-1.
1RWH 7KHVRFNHWRXWOHWVKDOOEHLQVWDOOHGQHDUWKHHTXLSPHQWDQG
VKDOOEHHDVLO\DFFHVVLEOH
)LJXUH 6LJQSRVWSRZHUFRQ Q HFWLRQ
 Continue with configuration using the signpost configuration software.
See “Configuring Operation Settings Using Configuration Software” on
page 26.
&RQQHFWLQJ6\QF&DEOHVWR6DYL
6LJQSRVW63;6HULHV
You connect sync cables to synchronize two to four signposts to cover an
area larger than is possible with a single signpost. Sync cables are ordered
separately.
 Connect the female end of the cable to the Sync In connector of the
signpost.
 Connect the male end of the cable to the Sync Out connector of another
signpost in the synchronized group.
 Create group number assignments.
See “Configuring Operation Settings Using Configuration Software” on
page 26.
3RZHU
FRQQHFWLRQ