User's Guide
Table Of Contents
- Savi Signpost SP-65X Series Installation Guide
- Contents
- Figures
- Introduction
- Hardware Installation
- Signpost Configuration
&+$37(5
6DYL6LJQSRVW63;6HULHV,QVWDOODWLRQ*XLGH
6LJQSRVW&RQILJXUDWLRQ
You configure a signpost using SmartChain Site Manager and modify
specific signpost parameters with a signpost configuration software
application for Savi Signpost SP-65X Series. This chapter provides steps for:
◆ Communicating with the signpost using RS-232
◆ Adding and configuring the signpost in SmartChain Site Manager
◆ Configuring the signpost settings using the configuration software
◆ Configuring the UHF reader module for specific signposts in
SmartChain Site Manager
Before you connect and configure a signpost, you must install the signpost
configuration software application on the service computer.
&RPPXQLFDWLQJZLWKWKH6LJQSRVW
8VLQJ56
You use an RS-232 cable to connect the RS-232 port on the signpost to the
service computer. Disconnect this cable from the signpost and service
computer after you complete signpost configuration. Figure 3-1 shows the
RS-232 serial port for the Savi Signpost SP-65X Series.
)LJXUH 6LJQSRVW56SRUW
56SRUW