User's Manual

CHAPTER 2
Savi Fixed Reader SR-650-101 Installation Guide 15
Designating Locations
and Connecting Cables 2
Before physically installing the Savi Fixed Reader SR-650-101, you must:
1. Consult a site plan to determine the reader’s installation location.
2. Connect power cables and network cables.
3. Supply power.
Planning a Site
To plan a site you must conduct a site survey and plan the RFID network
configuration. Once the site plan is in place, refer to it to determine where
to install Savi fixed readers. Follow the directions in this manual to ensure
proper installation of each Savi Fixed Reader SR-650-101.
Connecting Power Cables to the
Savi Fixed Reader
Note: The Savi Fixed Reader SR-650-101 is rated for use in severe
environments. For additional precautions, Savi recommends the use
of heat shrink tubing (Savi part number 680-02423-001) for units subject
to outdoor use.
Before you connect the Savi fixed reader’s power cable, be sure to check
relevant configuration or wiring diagrams.
The power source can be 12 to 24 VDC or 92 to 250 VAC. The socket-
outlet should be installed near the equipment and should be easily
accessible. The Savi Fixed Reader SR-650-101 does not require adjustment
or modification for different power sources. The appropriate power cable is
supplied based on the requirements specified when the order was placed.