User's Manual

Appendix B
56 Savi Fixed Reader SR-650-101 Installation Guide
Installing Heat Shrink Tubing
1. Place the heat shrink over the cable, and then mate the connectors.
The connectors are fully mated when the detent is engaged.
2. Position the heat shrink tubing so it is not completely against the
reader’s connector panel and covering the entire connector shell but is
.25 of an inch (6.35 mm) from the connector panel.
3. Use a hair dryer to shrink the heat shrink tubing.
Heat shrink tubing conforms to the connector shell when fully shrunk.
Removing Heat Shrink Tubing
1. Disconnect power from the unit prior to removing heat shrink tubing.
The heat shrink tubing must be at room temperature before removal.
2. Using a box cutter or pocketknife, carefully score the heat shrink tubing
along its full length. Score the heat shrink tubing only deep enough to
peel the tubing off the cable.
3. Lift a scored corner and peel back the heat shrink tubing. Use a small
pair of long-nosed pliers for assistance, if necessary.