User's Manual

A PPENDIX A
Savi Fixed Reader SR-650-101 Installation Guide 41
Using Telnet to Connect
to a Savi Fixed Reader
A
In this appendix, you configure your PC’s IP address and use Microsoft
Telnet client to connect the host computer to the Savi Fixed Reader
SR-650-101. Typically, you use SmartChain Site Manager auto-discovery
to connect to the reader.
Setting Up the Savi Fixed Reader
The Savi Fixed Reader SR-650-101 has an integrated network interface.
Note: Note that if you connect multiple readers to the same network, they
will all have the same default IP address of 10.7.19.11 and may create
network conflicts.
Once the hardware is installed, you set the IP address for the Savi Fixed
Reader SR-650-101, ping the reader to verify its connection, and configure
the Savi Fixed Reader SR-650-101 parameters.
Configuring Your PC’s IP Address
To set up the proper IP addresses, you must first configure the host
computer to communicate with the Savi Fixed Reader SR-650-101.
To specify the IP address:
1. At the host computer desktop, select Start > Settings > Control Panel.