User's Manual

CHAPTER 2

Savi Fixed Reader SR-650-101 Installation

b. After the ID display, two indicators flash at different rates. One is the

center bar of the segmented display and

the other is a small indicator

within the segmented display. If the indicators fail to flash, the Savi

Fixed Reader is non-operational.

2. If at any time you are not sure that the Savi Fixed Reader is operating

properly, reset the reader by disconnecting and

then reconnecting the

power source.

After resetting the Savi Fixed Reader SR-650-101, it should repeat the

power-on sequence described above.

The Savi Fixed Reader is now ready for you to verify communication

functions.

Note:

The Savi Fixed Reader SR-650-101 has a watchdog sensor that

automatically resets the reader if power fluctuations or other interruptions

occur that might affect the reader’s performance.

Setting Up the Savi Fixed Reader

SR-650-101

The Savi Fixed Reader SR-650-101 has an integrated network interface.

Note:

Keep in mind that if you connect multiple readers to the same

network, they will all have the same default IP address of 10.7.19.11 and

may create network conflicts.

Once the hardware is installed, you set the IP address for the Savi Fixed

Reader SR-650-101, ping the reader to verify its connection, and

configure

the Savi Fixed Reader SR-650-101 parameters.

Configuring Your PC’s IP Address

To set up the proper IP addresses, you must first configure the host

computer to be able to communicate with the Savi Fixed Reader

SR-650-101.

To specify the IP Address:

1. At the host computer desktop, select Start > Settings > Control Panel.