User's Manual
Table Of Contents
- User Guide
- About the Savi Mobile Reader SMR-650 and Mobile Computer
- Assembling and Using the Intermec Holster
- Recharging Batteries
- Printing Labels
- SMR-650 Reader Specifications
- Hardware Components
Savi Mobile Reader SMR-650 User Guide 29
Tag compatibility
SaviTag ST-6XX series and SaviTag ST-41X series
Interfaces
SMR-650-212: Cable with Intermec proprietary interface
and overmolded connectors. Cable is approximately 5 inches
(12.7 cm) in length
SMR-650-210 and SMR-650-213: Cable with serial DB-9
interface. Cable for SMR-650-210 is approximately 1 foot
(30.48 cm) in length. Cable for SMR-650-213 is
approximately 9 feet (2.74 m) in length.
RS-232 Interface
Data rate: 19.2 Kps
Flow control: CTS, half duplex communication, DTR for
switching between standby and active modes
Data format: 8 data bits, non-parity, 1 stop bit
Signals: TXD, RXD, DTR, and CTS
Antenna
External UHF: 50 Ohms matched external helical antenna
(attached using SMA connector)
Integrated (LF): Ferrite Core
Shock and vibration
Shock: Drop from 4-foot (1.22 m) height on the concrete
floor in accordance with IEC 68 Series (MIL-STD-810E
Method 514.4 Category 10), mechanical shock, transit drop
methods 516.4 per National Safe Transit Association (NSTA)
project 1A.
Vibration: Random vibration, 3 axis, 60 minutes each axis
MIL-STD-810E Method 514.4 Category 10 Procedure 1
Minimum
Protection type
Sealed to IP64 (protection against objects larger than 1mm
(.04 inches) in diameter and protection from water falling as
much as 15 degrees from vertical)