User's Manual

Caution: Do not place tags on the side of the pallet that locks into the aircraft. Place it on the side that faces away
from the forklift.
Mounting the Tag
Before you install the tag, make sure the following materials, which are included with the tag, are available:
• Pressure sensitive tape (PST)
• Two tie wraps
Whichever mounting method you select, the goal is to prevent accidental loss of the tag by sudden impact or vibration
during transport. The best mounting method for your application depends on the material you attach the tag to and your
personal preference.
Mounting with Tape
1. Open the tag mounting kit and remove the roll of PST.
2. Unroll the tape completely. The PST has two sides of adhesive. Immediately apply the entire length of PST to the
back of the tag
3. Peel the backing from the PST to expose the adhesive.
4. Position the tag on the asset and press firmly until the tag sticks to the asset.
Mounting with Tie Wraps
The ST-616 tag has mounting holes at each end of the tag, as shown in the figure below:
Mounting hole for tie wrap
To mount the ST-616 tag using tie wraps, thread a tie wrap through each mounting hole and affix the tag to the asset.
8 | OpenTopic | Savi ST-616 Asset Tag Description
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/