Install Guide

Mounting SaviTag ST-614/ST-615
SaviTag ST-614/ST-615 Installation Guide 23
Applying the Tag
Mounting SaviTag ST-614/ST-615 Using Rivets
Note: If you want to mount SaviTag ST-614/ST-615 using rivets,
consider removing the PST as outlined in “Removing Pressure Sensitive
Tape-Mounted Tags” on page 25.
1.
Determine where the SaviTag ST-614/ST-615 is to be attached to the
asset.
2. Use a marker to mark on the shipping container or asset the location of
the rivet holes on the tag.
3. On the asset, drill holes at the locations you marked in step 2.
4. Return to the location where the tag is to be attached to the asset. Align
the rivet holes on the tag with the rivet holes you made in step 3.
5. Push the head of the rivets through the tag.
Figure -5 Insert rivets
6. Use the handheld rivet gun to clip the nail of the rivet and secure the tag
to the asset. Avoid fastening the rivets too tightly so as not to damage the
tag.
1. Return to the location
where the tag is to be
attached to the shipping
container or asset.