Install Guide

CHAPTER Installing SaviTag ST-614/ST-615
16 SaviTag ST-614/ST-615 Installation Guide
The SaviTag has an algorithm to identify when it is in an idle environment
and manage its power consumption. In addition, you can put the SaviTag
ST-614/ST-615 to sleep or wake it from a sleeping state manually by
enabling or disabling the UHF receiver. With the UHF receiver disabled, the
tag stops responding to tag collections from any fixed or mobile reader
initiating UHF collection commands.
To put the SaviTag ST-614/ST-615 to sleep using the SmartChain Mobile
Manager, follow these steps:
Note: SmartChain Mobile Manager cannot process this command while
the Savi Mobile Reader is charging. If the external power supply to the
mobile reader is plugged in, you must disconnect it and remove the
mobile device from the charging unit to run the command.
1. Start SmartChain Mobile Manager.
2. On the Main Menu, select Next >> to view the second page of
commands.
3. Select Enable/Disable Tag UHF Receiver.