Install Guide

Required Tools and Materials
SaviTag ST-614/ST-615 Installation Guide 13
Installing SaviTag ST-
614/ST-615
Required Tools and Materials
Before you begin installation of SaviTag ST-614/ST-615, make sure you
have the following materials available:
◆ SaviTag ST-614/ST-615
◆ Savi SmartChain Client Tools 4.0 or TAV Tools 3.6x or later
◆ Pressure sensitive tape (provided)
◆ Two (2) zip ties (provided) or:
◆ Alternatively: Two (2) rivets and a handheld rivet gun
Commissioning SaviTag ST-614/ST-
615
You can commission SaviTag ST-614/ST-615 using the low-frequency UHF
interface.
You can send a low frequency command from SmartChain Mobile Manager
to SaviTag ST-614/ST-615 to enable the UHF receiver.
Note: SmartChain Mobile Manager cannot process this command while
the Savi Mobile Reader is charging. If the external power supply to the
mobile reader is plugged in, you must disconnect it and remove the
mobile device from the charging unit to run the command.
1. Start SmartChain Mobile Manager.
2. On the Main Menu, select Next >> to view the second page of
commands.