User's Manual

Installation Guide For
SaviTag ST-602-14 Asset Tag
Page 2 of 5 pages ELECTRONIC COPY
NOT CONTROLLED IF PRINTED
Date Prepared Revision Revision Date Revision Approval
June 27, 2007
1.0
June 27, 2007 Ron Stein
DRAFT
- 2 - ST-602-14 Installation Guide
The SaviTag ST-602-14 tag is identified by an embossed logo on the front surface. Onthe back
surface, one or more labels containing the product model number, and a unique serial number in both
bar code and numerical format identify the product. The tag’s markings also identify relevant
compliance markings (e.g., FCC).
The ends at the length of the tag have holes and slots to enable the tag to be mounted on to a
variety of surfaces and items. In addition, the back surface of the tag is flat and smooth to
enable the tag to be affixed by double-sided tape or epoxy.
An optional bracket accessory, the STA-1602 shown in Figure 4, is available to facilitate
additional mounting scenarios. It lso provides spacing between the tag’s antenna and the
object to which the tag is mounted to minimize degradation RF transmission. This is
especially important when the tag is mounted on large flat metal surfaces. The tag affixes to
the bracket with a pair of supplied rivets.
The SaviTag ST-602-14 tag is primarily intended for indoor use, but can withstand harsh
environments and outdoor use where it can be exposed to rain, snow, dust, and direct
exposure to sunlight.
The tag’s battery life is rated at a nominal 5 year life when used under typical operating
conditions. [Ron-you should define “typical” operating conditions—ex. 2 reads per day] The
tag contains an internal lithium battery and therefore should be discarded according to local
safety requirements.