User's Manual
Table Of Contents
0RXQWLQJWKH6LJQSRVWV
(FKR3RLQW6LJQSRVW,QVWDOODWLRQ*XLGH
7DEOH 0RGHO63DQG636LJQSRVW&RQQHFWRUVDQG/('V
Connectors
and LEDs
Description
Power The input power is connected here.
RS-232 Used to connect to a computer for setup and diagnostics by
installers and technicians.
Antenna The external loop antenna connects here.
Sync In Used to synchronize 2 to 4 Model SP-600-201 or SP-600-211
Signposts to cover an area larger than is possible with a
single Signpost. This connector can also accept DC volts
from another Signpost to avoid running separate power lines
when two or more Signposts are synchronized.
Sync Out Used to synchronize 2 to 4 Model SP-600-201 or SP-600-211
Signposts to cover an area larger than is possible with a
single Signpost. This connector can also output DC volts to
another Signpost to avoid running separate power lines when
two or more Signposts are synchronized.
Sensor 1 A closure on these two pins will trigger a predefined
Signpost action.
Sensor 2 A closure on these two pins will trigger a predefined
Signpost action.
Status This LED indicates when power is applied and the Signpost
mode of operation:
On ½ second, off ½ second indicates normal operation
On 1 second, off 1 second indicates the Signpost is off but
powered
On continuously indicates the Signpost is transmitting a CW
signal