User's Manual
Table Of Contents
- U.S. Regulatory Approvals
- Conventions in this Guide
- Introduction
- EchoPoint Reader Installation
- Maintenance
6HWWLQJ8SWKH1HWZRUN$GDSWHU
(FKR3RLQW5HDGHU65,QVWDOODWLRQ*XLGH
9. Type ntpserverip=10.7.20.18 (or whatever valid NTP
address you want to assign) and press Enter to set the NTP
server IP address that the adapter will listen to. See
Figure 2-21.
)LJXUH 7HOQHW1736HUYHU,3$GGUHVV'LVSOD\
» To set adapter parameters:
1. Type combinetime=ENABLE (DISABLE) and press Enter
to enable (disable) the time of event data from the reader to
combine with the time of the tag received from the signpost.
See Figure 2-22.
)LJXUH 7HOQHW&RPELQH7LPH&RPPDQG
2. Type ntpsynchro=ENABLE (DISABLE) and press Enter to
enable (disable) the reader time and date to synchronize with
the NTP server as shown in Figure 2-23.