User's Manual
Table Of Contents
- U.S. Regulatory Approvals
- Conventions in this Guide
- Introduction
- EchoPoint Reader Installation
- Maintenance
6HWWLQJ8SWKH1HWZRUN$GDSWHU
(FKR3RLQW5HDGHU65,QVWDOODWLRQ*XLGH
4. Type reset and press Enter to make the gateway IP address
take effect.
5. Type hostip=10.7.20.18 (or whatever valid IP address you
want to assign) and press Enter to set the adapter host IP
address to the input one. See Figure 2-19.
)LJXUH 7HOQHW+RVW,3$GGUHVV'LVSOD\
6. Type reset and press Enter to apply the host IP address.
The host is the computer to which the adapter sends the event
data.
7. Type netmask=255.255.128.0 (or whatever valid mask you
want to assign) and press Enter to set the adapter network
mask to the input one as depicted in Figure 2-20.
)LJXUH 7HOQHW1HWZRUN0DVN'LVSOD\
8. Type reset and press Enter to make the netmask take effect.