User's Manual
Table Of Contents
- U.S. Regulatory Approvals
- Conventions in this Guide
- Introduction
- EchoPoint Reader Installation
- Maintenance
6HWWLQJ8SWKH1HWZRUN$GDSWHU
(FKR3RLQW5HDGHU65,QVWDOODWLRQ*XLGH
» To assign a new local IP address to the adapter and modify
gateway and netmask addresses:
1. At the cursor, type localip=10.7.20.118 (or whatever valid IP
address you want to assign) and press Enter to set the adapter
IP address to the input one.
See Figure 2-17.
)LJXUH 7HOQHW/RFDO,3$GGUHVV'LVSOD\
2. Type reset and press Enter to cause the IP address to take
effect.
Now you can use Telnet to connect to the adapter at the
new IP address.
3. Type gateway=10.100.4.1 (or whatever valid IP address you
want to assign) and press Enter to set the adapter gateway IP
address to the input one as shown in Figure 2-18.
)LJXUH 7HOQHW*DWHZD\,3$GGUHVV'LVSOD\