User's Manual
&RQQHFWLQJ3RZHUWRWKH(FKR3RLQW5HDGHU
(FKR3RLQW5HDGHU65,QVWDOODWLRQ*XLGH
&RQQHFWLQJ3RZHUWRWKH(FKR3RLQW
5HDGHU
Note: While the EchoPoint Reader SR-600-101 is rated for
use in severe environments, the power and network
connector seals may deteriorate with repeated
installation and removal. Therefore, Savi recommends
the use of heat shrink tubing (Savi part number
680-02423-001) for units subject to outdoor use.
When connecting the EchoPoint Reader’s power cable, be sure to
check any relevant configuration or wiring diagrams beforehand.
The power source can be 6 to 15 VDC, 110 VAC, or 220 VAC.
The socket-outlet shall be installed near the equipment and shall
be easily accessible. The EchoPoint Reader SR-600-101 does not
require adjustment or modification for different power sources.
An appropriate power cable is supplied, based on the
requirements specified when the order was placed.
You can also power the EchoPoint Reader SR-600-101 from a
Savi Solar Power Module, or by vehicle power. A fixed-length,
molded cable is supplied with the Solar Power Module. The
Vehicle Power Cable can be purchased as an accessory item.
» To connect the power cable to the reader:
1. Select the appropriate power cable for the power source.
¤ The 220 VAC cable terminates in a European connector.
¤ The 110 VAC cable terminates in a North American
connector.
2. If installing the EchoPoint Reader SR-600-101 in an outdoor
location, slide heat shrink tubing onto the power cable before
connecting the cable to the reader.
a. Follow the instructions included with the heat shrink kit
to apply the tubing to the cable.