User's Manual

Installing the SMR-410R
4
Installing the SMR-410R
Charging the battery
Use either of the following methods to charge the NiCad
battery.
• Optical Link Method
1. Place the battery in the reader.
2. Attach the Optical Interface Adapter to the reader as described in
the section Installing the Optical Interface Adapter, later on this
page.
3. Connect the AC adapter to the Optical Interface Adapter.
4. Wait at least 15 hours for the battery to charge.
• Battery Charger Method
1. Place the battery in battery charger (available separately).
2. Wait at least 2.5 hours for the battery to charge.
Inserting the Battery
1. Hold the reader so that the handle points down.
2. Hold the battery under the reader handle.
3. Slide battery into the reader handle and push firmly in.
Installing the Optical Interface Adapter
The following figure shows the Optical Interface Adapter and its
connectors. Use the RS-232 connector to connect devices that communi-
cate with the SMR-410R. Attach the AC adapter to the AC adapter con-
nector.