User Manual

Checking the Batteries
12
Placing the SMR-410R in Suspend Mode
To place the SMR-410R in Suspend Mode, press . Once in the Sus-
pend Mode the SMR-410R saves all memory and cuts power to the
hardware.When you want to use the unit again, press and the unit
begins functioning from the point from exactly where it was when
placed in Suspend Mode.
Placing the SMR-410R in Storage Mode
If you do not plan to use the SMR-410R for seven days or longer, place
the unit in Storage Mode.
To place the SMR-410R in Storage Mode (these instructions are also
printed on the side of the unit below the antenna):
1. Press to place the unit in Suspend Mode.
2. Press and hold and the symbol on the cursor key,
in that order. Then release the keys.
3. Press a second time.
4. Press and then to highlight Storage on the Boot Loader
menu.
5. Press enter.
6. Remove the NiCad battery.
Removing the NiCad battery
1. Hold the reader with the handle pointing right or left.
2. Push battery inward slightly while at the same time pressing the dot
on the base of the battery. Pull the battery out about a half inch.
3. Squeeze the two yellow buttons with your thumb and forefinger to
release the latches in the handle.
4. Slide the battery out of the handle.
Note: Do not remove the NiCad battery for more than 10 minutes without first
placing the SMR-410R in Storage Mode. Otherwise the Lithium Bridge
battery discharges.
I
O
/
I
O
/
I
O
/
I
O
/
I
O
/
F3
2
2
2
I
O
/
I
O
/