User Manual

ManualsBrandsSavage Universal ManualsDigital Camera AccessoriesSavage Universal - LiteShaper Flexible LED Panel

LITESHAPER FLEXIBLE LED PANEL

SETUP & USAGE

INSTRUCTIONS

professional photography made simple

800.624.8891 savageUniversal.com

4. 5. 6. 10. 11.3. 7. 8. 9.

13.

12.

AC ADAPTER PORT

BATTERY LEVEL

INDICATOR

REMOTE RECEIVER

9” BATTERY CABLE

BATTERY PACK

SPEEDLIGHT ATTACHED TO

FRONT VELCRO STRAPS

ATTACH VELCRO DIFFUSER TO

FRONT OF PAD FOR SOFT LIGHT

For Speedlight Use

Attach the power bank by strapping it into the 3 Velcro straps on the bottom back of the panel. Strap the remote receiver to the back of the power bank using the top

strap. Connect the power bank to the pads remote receiver using the included 9” (23cm) battery cable. Strap your speedlight to the front of the exible panel using both

of the Velcro straps. Be sure not to cover the infrared sensor on your speedlight

Apply the included Velcro panel diffuser to the top and sides of the frame when a softer, more shadowless modeling light is preferred. Remove when high contrast is

desired. Attach the speedlight to your camera. Turn the power switch for the power bank by switching to the “-” position and the pad should light. The light output can

be adjusted using the included remote control.

Charging the Power Bank

Begin by making sure the power bank is fully charged. Plug the included AC adapter into a household power source.

Plug the other end into the top of the power bank. The front of the LED bank should turn green to indicate that the power

bank is charging. When all 4 LEDs turn green, the battery is fully charged. As the power bank drains from use, the green

bars will gradually go dark. When all LEDs goes dark, the power bank must be recharged.

The pad will run approximately 3 ½ hours at full power between charges.

Contents

1. 10.5” x 12” (27cm x 30cm) LiteShaper LED panel

2. Metal panel frame

3. Remote control

4. Shoe adapter

5. Light stand adapter

6. Power bank

7. Power bank light stand holder

8. Panel diffuser

9. Frame diffuser

10. 7.5’ (2.3m) AC adapter

11. 24” (61cm) Battery cable

12. 9” (23cm) 9” Battery cable

13. Carry bag

ATTACH BATTERY & RECEIVER TO BACK OF PAD ATTACH SPEEDLIGHT TO FRONT OF PAD ATTACH DIFFUSER (OPTIONAL)

Summary of content (2 pages)

PAGE 1
® ® LITESHAPER FLEXIBLE LED PANEL SETUP & USAGE INSTRUCTIONS 13. 2. Contents 1. 10.5” x 12” (27cm x 30cm) LiteShaper LED panel 2. Metal panel frame 3. Remote control 4. Shoe adapter 5. Light stand adapter 6. Power bank 7. Power bank light stand holder 8. Panel diffuser 9. Frame diffuser 10. 7.5’ (2.3m) AC adapter 11. 24” (61cm) Battery cable 12. 9” (23cm) 9” Battery cable 13. Carry bag 1. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
PAGE 2
® ® LITESHAPER FLEXIBLE LED PANEL SETUP & USAGE INSTRUCTIONS Remote Control Operation The remote is pre-paired to Switch 1 located at the bottom of the remote. Press the “Bri-” (Brightness) button and the power level of the pad will decrease. Press the “Bri+” button to increase. Press the “Main Off” button to turn all connected pads off simultaneously and the “Main On” button to light all connected pads. The remote can be used to control up to 4 Savage LiteShaper Flexible LED Panels.