Manual

BE SURE TO READ AND UNDERSTAND ALL OF THE CAUTIONS AND WARNINGS ON ALL
SOLVENTS AND CHEMICALS PRIOR TO USE. FOLLOW THE MANUFACTURER’S
INSTRUCTIONS FOR BEST CLEANING RESULTS.
1. Prepare an area for cleaning the firearm with a suitable surface, adequate ventilation, correct
caliber cleaning rod, brush, patches, powder solvent, and oil.
2. Remove the bolt.
3. Lay the firearm horizontally with the ejection port facing down.
ALWAYS STARTING FROM THE CHAMBER END, PUSH THE CLEANING ROD THROUGH THE
BORE AND OUT THE MUZZLE END.
4. Using a small amount of powder solvent on the brush, push the cleaning rod through the
barrel several times.
5. Unscrew the brush from the cleaning rod and replace it with a patch tip.
6. Push a new patch through the bore starting from the chamber end and out the muzzle.
7. Repeat the prior step (# 6) several times.
8. Push a new patch saturated with gun oil through the bore.
9. Push a new dry patch through the bore to remove the excess oil.
10. When done, always verify that the “THREE POSITION SAFETY” is operational as explained in
the beginning of SECTION 2.
CHECK THE BORE CAREFULLY WHEN DONE TO BE SURE THERE ARE NO OBSTRUCTIONS
(I.E. PIECES OF CLEANING PATCH, ETC.).
A VERY THIN FILM OF OIL IS SUFFICIENT PROTECTION – DO NOT OVER OIL!!!
YOUR GUN IS A MECHANICAL DEVICE WHICH WILL NOT LAST FOREVER AND IS SUBJECT
TO WEAR. CONTACT SAVAGE ARMS SERVICE DEPARTMENT FOR PERIODIC INSPECTION,
ADJUSTMENT AND SERVICE.
FAILURE TO PROPERLY MAINTAIN YOUR FIREARM MAY LEAD TO DAMAGE AND/OR
SERIOUS INJURY TO THE SHOOTER OR BYSTANDER.
PROTECTING METAL SURFACES
1. In order to be able to reach all surfaces, remove the bolt prior to cleaning and oiling.
2. With a soft cloth, remove any foreign matter (i.e. mud, twigs, grass).
3. Apply a thin coat of gun oil on all cleaned metal surfaces. Rubbing may be necessary to
remove any signs of rust.
4. Where accessible, clean and lightly oil interior metal surfaces.
5. When done, always verify that the “THREE POSITION SAFETY” is operational as explained in
the beginning of SECTION 2.
DO NOT DISASSEMBLE THE BOLT ASSEMBLY.
CHECK THE BORE CAREFULLY WHEN DONE TO BE SURE THERE ARE NO OBSTRUCTIONS
(I.E. PIECES OF CLEANING PATCH, ETC.).
SECTION 3
PARTS LIST AND DIAGRAM
ACCUTRIGGER™
TOP LOAD OR DETACHABLE BOX MAGAZINE
FOR MORE INFORMATION, PLEASE VISIT OUR WEB SITE AT: WWW.SAVAGEARMS.COM