Manual

Dealing with problems
26GB07.01
14 Dealing with problems
14.1 Cause and correction of malfunctions
Gun maintenance (cleaning and inspection)
according to the instructions can prevent
malfunctions.
Should, nevertheless, a malfunction occur during
shooting, proceed as follows:
1. Remove magazine and unload the gun
(see section 5.8.1).
2. Open the bolt.
– The round or cartridge case is pulled out of
the barrel chamber and ejected.
3. Check that no bullet, round, cartridge case or
foreign matter is in the barrel chamber or
barrel. If a projectile is lodged in the bore, strip
the gun (see section 8) and have the blockage
removed with a suitable tool by a qualified
gunsmith.
4. Remove round, cartridge case or foreign
bodies. Clean, lubricate and assemble the gun
(see sections 12 and 9).
5. Have the gun inspected by an armourer or
gunsmith.
WARNING!
Uncontrolled discharge of shot
May lead to death or severe injuries
• Hold the gun pointed in the firing direction
(safe direction) and keep your fingers off the
trigger while you carry out the steps
described below.