Manual

Accessories
22GB07.01
11 Accessories
11.1 Scopes
11.1.1Installing the scope
1. Slacken off the Allen screws 204 on the scope
rail 200 until the scope can be slid on.
2. Hold the scope at an angle and parallel to the
rifle.
3. Snap the scope rail 200 from the left side onto
the receiver dovetail.
4. Slide the scope to the front until the scope rail
stop firmly abuts against the receiver housing.
5. Tighten the Allen screws 204.
6. Check that the scope rail stop abuts firmly
against the receiver and that the scope is
securely mounted on the gun.
7. Attach the mirage band (see section 11.4).
11.1.2Removing the scope
1. Remove the mirage band (see section 11.3).
2. Slacken off the two Allen screws 204 on the
scope rail 200.
3. Lift off the scope to the left side.
11.2 Adjusting eye relief length
1. Slacken off the Allen screws 205 until the
scope can be slid along its own axis.
2. Select the desired eye relief length of the
scope.
3. Tighten the Allen screws 204.
Abb. 23
656
657
204