Manual

Training system
21 GB 07.01
10 Training system cal. 22 lr.
(optional)
10.1 Caliber conversion cal. 22 lr.
Procedure:
1. Remove barrel (see section 8.3)
.
2. Remove magazine ejector. Unhook the
magazine ejector spring 301 downwards from
its upper retainer and allow it to relax.
.
3. Now unhook the lower claw from the magazine
ejector 302 and remove it.
.
4. Lift the bottom end of the magazine ejector,
swing it to the left and remove it from the upper
aperture.
5. With the slot facing downwards, insert barrel
450 into the receiver. Align slot with the slot in
the receiver.
6. Place insert 308 into the receiver from below.
7. Lightly tighten clamping screw 306a and
remove the magazine (see section 5.8.1).
8. Insert the magazine adapter into the magazine
well until it contacts the barrel.
9. Retain magazine adapter with screw 656.
.
10.Check correct barrel location by lightly rotating
the barrel in both directions.
Note:
• On both sides there should be about the same
gap between the magazine adapter and the
magazine well.
11.Check that the screw 656 is well seated. If
necessary, tighten it.
12.Tighten the clamping screws 306/306a and
install the stock (see section 9.2).
13.Cock the bolt (see section 5.7.1), insert (see
section 5.7.3) and then lock it.
14.Cycle the bolt to check that its action is
smooth.
15.Insert the magazine 658 until it snaps in.
16.Sight in the gun (zeroing).
.
Abb. 19
Abb. 20
Abb. 21
301
302
302
Abb. 22
656
657
658