Manual

Assembly
20GB07.01
9.2 Installing the stock
Corresponding figure, see Fig. 16
Procedure:
1. Lightly turn the rear stock retention screw 514
by hand.
2. Lightly turn the rear stock retention screw 512
by hand.
3. Tighten rear stock retention screw 514.
4. Tighten front stock retention screw 512.
Note:
• Correct torque for the stock retention screws is
achieved by grasping the end of the spanner
and applying enough twist to raise the gun into
the vertical position.
9.3 Fitting the carrying sling
Corresponding figure, see Fig. 17.
Procedure:
1. Insert the open sling swivel.
2. Press the knurled knob with the plunger and
turn it to the right until the hinged plate snaps
onto the stud.
3. Remove the knurled knob from the plunger by
turning it to the right.
4. Insert the stud of the front sling swivel also into
the front sling swivel bushing 48.
Note:
• Securely tighten the knurled knob on the
plunger prior to turning.
• The sling swivel must be aligned exactly 90° to
the orientation of the barrel.
CAUTION!
Gun may be damaged
• The spanner must not be extended by
attaching a tube.
• If a torque spanner is used to tighten the
stock retention screws, apply 5 Nm.