Manual

15 GB 07.01
Handling Safety loc
k
5.9.2 Setting the trigger position
Refer also to Fig. 8.
The trigger 710 can be displaced along the
longitudinal axis by set screw 711.
Procedure:
1. Slacken off set screw 711.
2. Shift the trigger 710 to the desired position.
3. Tighten the screw 711.
Caution:
• Ensure that in the foremost position, the trigger
does not contact the unlock slide 708.
• In the rearmost position, the trigger may not be
located more to the rear, if the trigger begins to
cover the adjusting screw 709a. Otherwise this
could hinder the correct function of the trigger
action; in the worst case, firing a shot is not
possible anymore.
5.9.3 Setting the let-off point
Earlier let-off:
– Turn set screw 709a clockwise.
Later let-off:
– Turn set screw 709a anticlockwise.
Note:
• To be able to adjust the let-off point, the trigger
710 must be in a position that allows access to
set screw 709a.
6 Safety lock
The SAUER SSG 3000 safety system is an
indirect firing pin safety mechanism.
It locks the trigger, the trigger stop, and the firing
pin shoe and thus blocks all safety-relevant
components.
Its function is based on a principle proven a million
times over: A single function – a single button.
– The unlock slide is located within the trigger
guard ahead of the trigger where it is both well
protected and tactile.
– The safety lock is located on the receiver side
behind the bolt handle, where it is both visible
and easy to operate.
6.1 Safety OFF
Procedure:
1. Slide the unlock slide 708 up to the stop with
your trigger finger.
– The safety slide 313 slides also upwards
and exposes a visible red warning mark.
Note:
Gun unlocked:
– Safety lock up
– Red mark visible
Abb. 9, Gun unlocked:
708
313