Manual

Handling
14GB07.01
5.9 Trigger
The SSG 3000 features a trigger with let-off point.
Note:
• The trigger pull weight has been set to approx.
15 N (1.500 g) at factory.
The match trigger is a let-off point trigger with
adjustable take-up.
– The trigger must be pulled until it reaches a
noticeable resistance (trigger let-off point).
– The shot is fired after the resistance has been
overcome.
5.9.1 Setting the take-up
Reduce take-up:
– Turn set screw 709b clockwise.
Increase take-up:
– Turn set screw 709b anticlockwise.
Note:
• When setting the take-up, the trigger must be
in a position that allows access to set screw
709b.
• The take-up travel cannot be adjusted to
"zero", there will always be a travel by design.
WARNING!
Uncontrolled discharge of shot
May lead to death or severe injuries
• For safety reasons the trigger pull weight
must only be modified by a qualified
gunsmith. He can adjust the trigger pull
weight between approx. 13 N (1.300 g) and
17 N (1.700 g).
• Any screws sealed with red varnish must not
be adjusted by the user. If these screws are
manipulated, the warranty will be void.
Abb. 8
CAUTION!
Gun may be damaged
• The screw for reducing the take-up must only
be turned clockwise to a degree that the
safety lock will still work properly.
• If the free movement of the safety lock is
impeded, the screw must be immediately
turned back anti-clockwise until the normal
safety lock function is restored.
709b709a 710
711