Manual

Handling
12GB07.01
5.7.2 Removing the bolt
Procedure:
1. Move the buttstock cheekpiece down as far as
possible or remove it (see section 7.1).
2. Release the gun safety (see section 6.1).
3. Open the bolt and draw it back approx. half of
its travel.
4. Activate the safety catch (see section 6.2).
5. Rotate the bolt to the left (approx. 90°), until
the bolt channel becomes visible in the bolt
handle guideway.
6. Extract the bolt to the rear.
5.7.3 Inserting the bolt
Procedure
Procedure:
1. Move the cheekpiece down as far as possible
or remove it (see section 7.1).
2. Lock the gun (see section 6.2).
3. Cock the bolt (see section 5.7.1).
4. Insert the cocked bolt into the receiver by
rotating it slightly. The removal position (bolt
handle turned to the left by 90°, see Fig. 5/
5.+6.) is the best position to install the bolt.
5. Rotate the bolt until the bolt handle slides into
the guideway of the receiver (see Fig. 5/3b.).
6. Slide the bolt up to the front and lock it.
7. Install or adjust the buttstock cheekpiece
(see section 7.3).
Firing
Abb. 5, Removing the bolt
1.
2.
3a
3b.
4.
6.
5.
WARNING!
Uncontrolled discharge of shot
May lead to death or severe injuries
• The gun must be unloaded.
CAUTION!
Gun may be damaged
• Never use force when inserting the bolt.
CAUTION!
Danger of collision of cheekpiece with
cocking indicator (if the cheekpiece has not
been removed)
• When sliding in the bolt, the cocking indicator
must not face directly downwards.