Manual

Assembly Mounting telescopic isi-Mount
19 07.03GB
8.4 Fitting the sling attachment
Corresponding figure, see Fig. 17.
Procedure:
1. Insert the bolt of the rear sling attachment into
the sling attachment bushing 808.
2. Press in the spring bolt.
3. Gently turn the sling attachment until the bolt
safety lock engages.
4. Insert the bolt of the front sling attachment into
the front sling attachment bushing 702.
Note:
• The sling attachment must be aligned exactly
90° to the orientation of the barrel.
• The bolts must protrude clearly above the
edge of the sling attachment body.
9 Mounting telescopic isi-Mount
The housing of the SAUER 303 is already
prepared for the mounting of the new SAUER
telescopic sight "isi-Mount“ (individual, selective,
integrated) (see Fig. 24).
This new mount guarantees the lowest design
type, highest shot strength and absolute
repeatability after taking off and putting on the
telescopic sight. In addition the glass can always
be mounted with the proper spacing due to the
availability of 3 grooves in the front area of the
housing.
Also the glass can be moved from the front to the
rear groove (or opposite) without point of impact
relocation. In this way the marksman can adjust
the eye distance to the current conditions or his
clothing thickness.
9.1 Putting on the telescopic sight
Procedure:
1. Lift up the locking lever of the mounting upper
section and turn counter-clockwise.
2. Guide the telescopic sight slanted from the
side into the housing grooves, so that the
cross ribs of the mounting upper section lies
congruent with the desired groove.
3. Tip the telescopic sight in the housing grooves.
Fig. 23
CAUTION!
Gun may be damaged
• Do not use force when putting on and taking
off the telescopic sight.
Fig. 24