Manual

Dismantling
17 07.03GB
7.3 Front stock removal
Procedure:
1. Remove the sling attachment
(see section 7.1).
2. Insert the special Torx spanner with the short
end through the sling attachment bushing 702.
3. Turn the front stock screw with the special
spanner clockwise until the resistance at the
spanner disappears.
4. Remove the front stock 701 by pulling it to the
front.
7.4 Barrel removal
Procedure:
1. Remove/open magazine
(see sections 5.8.1 / 5.8.2).
2. Open slide and lock
(see section 5.7.2).
3. Remove the front stock
(see section 7.3).
4. Loosen the clamping screws with the supplied
Torx spanner 102 by approx. a half turn,
however do not remove.
5. Turn the Torx spanner 102 with the long end in
opening between the two screws until the stop,
so that the housing is slightly pryed open.
6. Remove the barrel 201 from the housing 100.
Fig. 18
Fig. 19
714
800
Fig. 20
Fig. 21
102