Manual

Hand cocking Dismantling
1607.03 GB
6.2 Decocking gun
Procedure:
1. Lay the thumb on the ribbed surface of the
cocking slide116 so that the tip of the thumb
half covers the cocking slide pin 117
(see Fig. 15).
2. Press the cocking slide slightly forward and
simultaneously press in the cocking slide pin
117 with the tip of the thumb (see Fig. 15).
3. Move the cocking slide slowly backwards.
4. Remove the thumb from the cocking slide.
Note:
Gun decocked:
– Red point on the stock handle under the
cocking slide is not visible.
– Cocking slide pin 117 is level with cocking
slide.
7 Dismantling
7.1 Removing the sling attachment
Procedure:
1. Firmly press in the spring bolt.
2. Turn the sling attachment gently and pull out.
Note:
• Clean and oil the sling attachment regularly.
7.2 Removing the main stock
Procedure:
1. Remove the sling attachment
(see section 7.1).
2. Unscrew the main stock screw in the hole of
the main stock 800 counter-clockwise using
the long end of the special spanner supplied.
3. Remove the main stock by pulling downwards.
WARNING!
Gun is ready to fire
May lead to death or severe injuries
• There must be no magazine in the gun.
• Before stripping your gun, ensure once again
that it is unloaded (see section 5.6).
Fig. 17, rear sling attachment bushing