Manual

Handling
1006.01 GB
5.6 Unloading the gun
Procedure:
1. Lock the gun (see section 6.2).
2. Aim the gun at a stop-butt.
3. Remove the magazine (see section 5.8.1).
4. Unlock the gun (see section 6.1).
5. Open the bolt.
– The cartridge or cartridge case is pulled out
of the barrel chamber and ejected.
6. Check that the round has been ejected and
there are no more rounds in the barrel
chamber.
7. Empty magazine.
8. Pick up ejected round and clean the gun.
The gun is unloaded.
5.7 Bolt
5.7.1 Cocking the bolt
In order to insert the bolt 100 into the gun, the firing
pin must be cocked.
A cocking indication provides information about
the cocking state of the bolt.
Procedure:
1. Insert the tapered end of the supplied key into
the side opening of the lock 113.
2. Turn the lock towards the cocking wheel until
it engages.
WARNING!
Gun is ready to fire
May lead to death or severe injuries
• Never let the gun out of your hands before it
is unloaded.
• The gun is loaded, a round is located in the
chamber of the barrel.
• Never place your hand over the ejection port
of the bolt.
WARNING!
Gun has not been cleaned sufficiently
May lead to death or severe injuries and
damage to the gun
• The gun must be cleaned after every
shooting session (see section 11).
Fig. 3, Cocking the bolt
Fig. 4, Tension indication 103 of the bolt
(left: cocked, right decocked)
113
1
03