User Manual

Step 8
Pae 12 www.sauder.com 414817
5
å
Carefully turn your unit over onto its front edes. Lay the UPPER BACK (D) over the upper openin of your cabinet.
å
Make equal marins alon the top and side edes of the BACK (D). Push on opposite corners of your unit if needed to make it "square".
å
Fasten the UPPER BACK (D) to your unit usin the NAILS (6).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (E).
å
Lay the LOWER BACK (I) over the lower openin of your cabinet. The tabs in the LOWER BACK should fi t in between
the tabs of the UPPER BACK (D).
å
Make equal marins alon the bottom and side edes of the LOWER BACK (I). Push on opposite corners of your unit if
needed to make it "square".
å
Fasten the LOWER BACK (I) to your unit usin the remainin NAILS (6).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (E).
å
Tap four TACK GLIDES (5) into the LOWER ENDS (H and J) and LEGS (M and N) as shown.
Do not stand the unit upriht without the
BACK fastened. The unit may collapse.
Caution
Unfi nished surface
Unfi nished surface
6
NAIL
(41 used in this step)
E
D
I
H
J
N
M
This hole should be left empty
for the SAFETY STRAP.