Instructions / Assembly

å
Fasten the BRACES (T) to the BOTTOM (E2). Use four BROWN 1-1/2" FLAT HEAD SCREWS (14S).
å
Fasten the BOTTOM (E2) to the LEFT END (B). Tighten two TWIST-LOCK® FASTENERS.
Step 7
416082www.sauder.com/services
Page 11
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
B
E2
How to use the SAUDER TWIST-LOCK
®
FASTENER
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Dowel end
J
Surface without
HIDDEN CAMS
Surface with
TWIST-LOCK®
FASTENERS
Surface with
TWIST-LOCK®
FASTENERS
E2
T
T
BROWN 1-1/2" FLAT HEAD SCREW
(4 used in this step)
14S
This hole should be
closer to this edge.