Instructions / Assembly

Carefully stand your unit upright.

Fasten a DOOR (L) to the RIGHT END (A). Use the screws in the HINGES.

NOTE: You may need to loosen the mounting screw to slide the HINGE slightly out of the slot. Retighten the screw before mounting

the HINGE to the END.

Fasten a BACK PLATE (18K) and KNOB (17K) to the DOOR (L). Use a BLACK 1-1/8" MACHINE SCREW (21S).

Push a DOOR STOP (4I) into the hole in the RIGHT BOTTOM (G).

Repeat this step for the other DOOR (L) and DOOR STOP (4I) to the left side of your unit.

Page 23

www.sauder.com/services415321

Mounting

screw

BLACK 1-1/8" MACHINE SCREW

(2 used for the KNOBS)

21S

17K

18K