Instructions / Assembly

Page 20 www.sauder.com/services 415321
15
15
S
t
e
p
Carefully turn your unit over onto its front edges. Lay the BACKS (I) over your unit.
Make equal margins along all four edges of the BACKS (I). Push on opposite corners of your unit if needed to make it “square”.
Fasten the BACKS (I) to your unit using the NAILS (1N).
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(44 used in this step)
1N
Unfi nished
surface
Unfi nished
surface
These perforations must be here.
These perforations must be here.
I
I