Instructions / Assembly

å
NOTE: Before beginning this step, separate the SLIDES from the SLIDE
SETS (16B) and the DRAWER PINS at the end of the SLIDES using a
SCISSORS. Save the DRAWER PINS. You will use them in Step 13.
å
Fasten the SLIDES (16B) to the RIGHT END (A) and UPRIGHT (C). Use
twelve SILVER 3/4" PAN HEAD SCREWS (52S) through the fi rst and last
holes in the SLIDES.
å
NOTE: The SLIDES are marked "RIGHT" and "LEFT" for easy identifi cation.
The SLIDES marked "RIGHT" will fasten to the RIGHT END (A) and the
SLIDES marked "LEFT" will fasten to the UPRIGHT (C). There are also
arrows on the SLIDES for correct positioning on the ENDS.
Step 2
413125 www.sauder.com/servicesPage 6
A
C
Surface with
HIDDEN CAMS
Surface with
HIDDEN CAMS
16B
16B
16B
16B
16B
16B
16B
DRAWER PIN
(Save for Step 13)
Using your Scissors, separate the SLIDES and the DRAWER PINS
Notch
Straight edge
LEFT SLIDES
Finished edge
RIGHT SLIDES
Finished edge
SILVER 3/4" PAN HEAD SCREW
(12 used in this step)
52S
Angled edge