Instructions / Assembly

å
NOTE: Before beginning this step, separate the SLIDES from
the SLIDE SETS (16B) and the DRAWER PINS at the end of the
SLIDES using a SCISSORS. Save the DRAWER PINS. You will use
them in Step 13.
å
Fasten the SLIDES (16B) to the RIGHT END (A) and UPRIGHT (C).
Use twelve SILVER 3/4" PAN HEAD SCREWS (52S) through the
fi rst and last holes in the SLIDES.
å
NOTE: The SLIDES are marked "RIGHT" and "LEFT" for easy
identifi cation. The SLIDES marked "RIGHT" will fasten to the
RIGHT END (A) and the SLIDES marked "LEFT" will fasten to the
UPRIGHT (C). There are also arrows on the SLIDES for correct
positioning on the ENDS.
Step 2
413123 www.sauder.com/servicesPage 6
A
C
Surface with
HIDDEN CAMS
Surface with
HIDDEN CAMS
16B
16B
16B
16B
16B
16B
16B
DRAWER PIN
(Save for Step 13)
Using your Scissors, separate the SLIDES and the DRAWER PINS
Notch
Straight edge
LEFT SLIDES
Finished edge
RIGHT SLIDES
Finished edge
SILVER 3/4" PAN HEAD SCREW
(12 used in this step)
52S
Angled edge