Instructions / Assembly

Step 13
413123www.sauder.com/services
Page 17
J
J
N
B
H
C
1R
(4 used)
DRAWER PIN
D486
D486
å
To insert the drawers into your unit, line up the grooves on the DRAWER SIDES
with the SLIDES on your unit. Slide the drawer into the unit until it is about 3" or
4" away from the back of your unit.
å
Using your hammer, gently tap two DRAWER PINS (from Step 2) into the holes
in your DRAWER SIDES (D486 and D488).
å
NOTE: The DRAWER PINS are used as a locking system for your drawer. When
the DRAWER PINS are in place, you will not be able to remove the drawer from
your unit.
å
Repeat this step for the other drawers.
å
NOTE: Be sure you insert the smaller drawer (N) into the top space of your unit.
å
Insert four METAL PINS (1R) into the hole locations of your choice in the LEFT
END (B) and UPRIGHT (C). Set the ADJUSTABLE SHELF (H) onto the METAL
PINS so the SHELF SNAPS are resting on the METAL PINS. Push on the
ADJUSTABLE SHELF until each METAL PIN "snaps" into the SHELF SNAPS.
å
NOTE: If you wish to change the location of the ADJUSTABLE SHELF, tap the
SHELF up with the palm of your hand.