Instructions / Assembly

å
Carefully turn over the lower portion of your unit until the fi nished edges are facing up as shown.
å
Insert four METAL PINS (1R) into an UPRIGHT (I).
å
Insert the METAL PINS (1R) in one end of the UPRIGHT (I) into the holes in the BOTTOM (J).
å
Fasten the LOWER SHELF (M) to the SMALL UPRIGHTS (F2 and H2). Use four BLACK 1-7/8" FLAT HEAD SCREWS (2S).
å
NOTE: Be sure the METAL PINS (1R) in the UPRIGHT (I) insert into the holes in the LOWER SHELF (M).
Step 10
413044 www.sauder.com/servicesPage 14
J
F2
H2
B
D
I
M
1R
BLACK 1-7/8" FLAT HEAD SCREW
(4 used in this step)
2S
Notch
Finished edge
Finished edge
This hole must be closer
to the notch than the hole
on the opposite surface.
Unfi nished
edge